The MCTrainer  educates you on the basics of traditional motor control systems. Reading and understanding ladder diagrams, basic control circuits and some advanced circuitry. The course calls for the use of a circuit drawing program called The Constructor. While it is not absolutely necessary, this program will certainly enhance your learning experience.

Wiring Diagrams vs. Ladder Diagrams

Ladder Diagram Logic & Basic Rules

Solenoids

Electromechanical Relays

Introduction to Timers

AC Motors

Sensing Devices

Two Wire Controls

Three Wire Controls

Separate Controls

Hand-Off-Automatic Controls

Sequence Controls

Reversing Controls

Jogging Controls

Timing Relay Circuits

• Administrator: Stan Kaltwasser